When the technician enters the wire code printed on unconnected wires, a computer program turns on the appropriate fiber, thereby causing a bright, flashing light to project from inside the target cavity guiding the technician to the proper insertion point. Correct insertion is confirmed by the elimination of light from that location, whereas insertion into an incorrect location leaves the flashing light visible. The system also employs high-quality synthetic speech in English or Spanish to read the pin number to the technician, further reinforcing the target location. Speech recognition is also available as an option permitting the technician to read wire codes to the system, thus eliminating the need for a keyboard or monitor.
Normally, technicians crimp pins on wires in advance of assembly. Wires may be identified during the assembly process by numeric code, bar code, color code, or if no codes are present, by electrical detection using a wrist-strap if the far end of the cable has already been assembled and can be electrically connected to the system. Field testing has shown that the system doubles assembly rate over manual methods while nearly eliminating errors. Because it greatly reduces the perceptual challenge of manually locating pin cavities in a complex connector, technician fatigue is greatly reduced permitting a continuous, high productivity rate throughout the work day. The Light Director is an accessory for cami’s CableEye PC-based cable test system.
EPP Europe 559
