Even though the smell of a gas is not necessarily an indicator of its impact on health, the UK’s Health and Safety Executive (HSE) concurs that rework professionals are right to be concerned. This is partly thanks to the fact that, after years of no-clean solder fluxes, lead-free has triggered a return to the electronics workbench of rosin-based fluxes. In its booklet “Solder Fume and You”, the H&S underlines the possible health hazards that can arise from the use of rosin-containing flux materials. When they are heated to the higher lead-free processing temperatures, they form fumes, or colophony, that can irritate the skin, respiratory tract and eyes. It warns that “Rosin-based solder flux fume is now regarded as one of the most important causes of occupational asthma in Britain”, and adds that if ventilation is poor, the effects may also be felt by others in the work area even if they are not involved in the soldering process.
Not surprisingly, the UK COSHH regulations include Maximum Exposure Limits (MEL) for rosin-based colophony. The HSE recommends that “exposures should be reduced to as far below the MEL as is reasonably practicable, for example by the provision and use of a suitable local extraction ventilation system”.
While health and safety is the top priority in deciding to invest in and optimize fume extraction systems, there are additional advantages to taking this step. One of these advantages is extended soldering iron tip life. OK International’s Market Development Manager, Craig Brown, explains: “At higher temperatures, lead-free fluxes tend to boil and spit, creating more colophony. Unless this is removed by an effective fume extraction system, it can form ‘black tip’, a solid black deposit on the solder iron. This acts as a barrier, preventing the solder from wetting and worse still, if it burns onto the tip itself, it reduces the tip’s thermal performance and useful life. We are now conducting tests to prove this theory”. OK International’s fume extraction systems all use multistage filtration with EU14 HEPA filters. Other variables include the type of extraction systems that will optimise air filtration: High Pressure (Tip) Systems fit onto the individual soldering irons, while high volume Arm Systems draw colophony from a general work area. Brown warns that opting for a low-cost, off-the-shelf air purifier will give manufacturers a false sense of security. “These units are often based on simple carbon filtration that removes the visible smoke particles to leave the impression of cleaner air. But they leave behind the more dangerous, smaller and invisible particulates. A good quality unit should offer at least a 99.5 % efficiency for removing particles down to 0.3 µm”.
EPP EUROPE 412
